Recent content by Doubledown

I know this is really old but I have been off an on resurrecting my blaster YSR swap project. Look on eBay and use the right side of a rz350, there some listed right now. Aftermarket too, but likely best for more modded motors. I do wonder if you can help me with mine. I need to know all I can...

I just have a motor I am building for my YSR swap, no wiring, stator etc. that I will need to mesh with the YSR harness so I will be starting brand new buying new harness, stator, CDI etc. Wondering should I be starting with the pre 2003 wiring harness stator etc. or should I get the early year...

Apparently I didn't have notifications set for this thread and happened to check back as I too let mine sit for a long time and am looking back into it. I would appreciate if you could help me by describing the mods you had to do to get the blaster motor fit. Kick start cut out, front cradle /...

Sorry to dredge up amega old post but I am getting to this same project thats been sitting for several years.I have been looking for a facotry paint code for the factory silver frame color. Looks like you got it right on an wanted to see if you tell me what you used. Also been trying to get more...

I understand that the blaster stock front sprocket retainer is the bolt on style however, I ordered a 420 sprocket to work with my YSR swap but the sprocket sent does not have the bolt holes and looks to be circle clip only. In looking at the drive axle diagram I see it is machined for a circle...

I have done a bit of research into carbs vs similar setups to my plan, perhaps to subjective, but I am not seeing a "best" answer. I am swapping a blaster motor into a YSR and picked up a used motor I am rebuilding. For now I am doing the bare minimum cost wise to get this bike through DMV...

Hoping to get some opinions from you all much more experienced in the blaster. I am bringing back a YSR blaster swap project and and doing a bit of planning before orders and need some help with wiring. I have no wiring harness now so I would like some help on how to best approach things...

New to the forum and have done a bit of searching in hopes of finding my specific answer with no luck. I would like to know what motor specific difference, if any, there are by model year. I am also trying to find if there is a way to ID the year of my motor by motor number or some other means...

Finally got the email verification system to work and freed me from posting prison. I am new to the forum and found it by seeing it be the top results for many of my blaster related searches. I am restarting a few YSR 50 project I have around, one of which I am doing a blaster swap on, thus...