Won't start

[blaster003]

I have a 2003 yamaha blaster and it will not start without gas poured into the plug hole it will run fine after for along time but it will not start without gas in plug hole what could this be has good compression and getting gas

 

[Quadman1]

Do not pour gas into the plug hole. Have you set your carb floats? Is the carb clean?

 

[Blaaster]

Do not put any more fuel down the plug hole as if you do it may not go for a real lot longer.

 

[blaster003]

Ok and floats are good and has good new reeds

 

[Blaaster]

The fuel enrichment system may be blocked.

When you try to start it keep your thumb off the throttle.

 

[blaster003]

Alright I'll try that tomorrow gonna ride rzr tonoght

 

[speedyslyder]

maybe get a helping hand from a local who know what he is doing

 

[Quadman1]

Polaris rzr? Please post pics.

 

[speedyslyder]

i think he meant razors as i believe his is 14yrs old?

 

[blaster003]

Ok when I could start it I could shut it off and start it again if the engine was still warm but not very eaisly cold for some reason I couldn't at all

 

[Blaaster]

Are you trying to say that it is hard to start when the engine is warm?

Or it is hard to start when the engine is cold?

In the case of the cold engine, apply the cold start button and keep your thumb off the throttle.

If your pilot circuit is out of whack it too will be hard to start.

 

[blaster003]

It's easier to start with the engine warm but still hard and it is pretty much impossible to start cold

 

[Blaaster]

Air leak or fuel starvation.

 

[speedyslyder]

read the carb section....if you dont take anything apart then it is not going to fix it self,get one of these small screwdrivers and take pilot jet out,sok it in carb cleaner for like 10minutes,hold up to a light above your head and you shoul;d be able to see through it,or buy a new pilot jet,take float chamber off to get to pilot jet.....