Thanks I'll look into it. I have a few things I need to get on his site anyways.
I need to find some case dowl pins too but I think I found them.
I'm full of questions now that I'm about to order parts and get this blaster done. I have had it for a 6 months and haven't even rode it yet.
My first question, when I was going to install my crank, I heated the bearings with a small torch and used a infrared thermometer to measure temp of the bearings while heating, turns out it didn't like reading accurately on a metallic surface because it colored the bearing, telling me it got a lot hotter then the 175-200 I was shooting for. Should I get new crank main bearings?
Also discovered my crank is off balance, because it had wobble when spinning. I know it's recommended to rebuild the stocker, but what rod should I buy? Almost seems like it's cheaper to buy a new crank.