where shoud i ground these 2 wires

[mystic mafia]

i have to ground 2 seperate wires and they have really small holes for the screws and it wont ground any where to the frame because all the screws are to big

 

[1bad442]

drill the hole bigger so the screws will go thru it

 

[mystic mafia]

i cant there is only like a 1mm piece of metal around it

 

[ZoMbIeCuStOmS]

so cut the ends and crimp on some new ones

 

[sheeblast]

you know, pictures will help out a lot more.

 

[mystic mafia]

pics of what the connecters? i was thinking drill a tiny hole in the plastics and just put on a steel screw and nut

 

[Whitty21]

it wont ground through the plastic...

 

[sheeblast]

that wont work, it needs to be grounded to the frame, take a pic of the connector and where it is located.

 

[mystic mafia]

i meant put bolt > wire> washer > plastics> nut

 

[Whitty21]

it still has to leave the nut somewhere, it needs to be metal on metal to the frame

 

[sheeblast]

ya again, aint going to work, did you not read what i said. all grounds must be connected to the frame.

 

[mystic mafia]

where it is located.

i cant i need a place to put it. that was the point of this thread

 

[brandoz28]

but is it by the grab bar? under the hood? where the heck is it???????

 

[sheeblast]

i cant i need a place to put it. that was the point of this thread

listen closely.
walk out to where you blaster is, take a picture of the connector. and where the wire is currently located.
it just aint hanging in mid air, it has to be connected to something else, if not, just throw the loose wire away.

 

[mystic mafia]

for some reason the ground didnt work to the frame only to the bumper? idky

 

[mystic mafia]

it is under the hood

 

[brandoz28]

they probably go under the screw for the voltage regulator

 

[sheeblast]

pictures dude, pictures.

 

[darederek]

ya man pics and we will help instantly but right now idk really how to help

 

[mystic mafia]

this is the wire end and it is off of my custom light set up but the hole is too small th drill it out anymore