What Carb to go with ?

[Nativeer3]

I'm gonna buy me a new carb but I can't deside witch one to go with ? I'm looking at Either a Mikuni 34mm or a keighn 34mm . The Mikuni is a whole lot cheaper but also heard better things about the keighn 34mm . I was going to get a port and polish job and a 3mm stroker kit , just tryin to get me the right carb for the set up ?

 

[roadkill]

that might be too big for your setup, do you have a 240 kit?

 

[royalt67]

With that level of motor, I would just go with either a 33 or 35 Keihin PWK. THe 34PJ works fine but the PWK is slightly newer tech. I'm sure the Mikuni is a fine carb but most peeps on here use Keihin so you will find better advice for those carbs.

 

[scotj77]

I'm runnin close to what you are talkin about doing and i have a 35mm pwk. just keep your eyes open a good deal will pop up on one. i got mine in great condition with a cable for 125

 

[brandoz28]

the PJ can be made to work, and i've seen them go for 50 bucks on ebay, but a 33 or 35mm pwk would be your best bet as royalt said

 

[Nativeer3]

Alright im deciding with the keihin 35mm pwk , but my only question is will i have to get the throttle cable also or will mine work ? I know this sounds stupid but dont know .

 

[Whitty21]

go with motion pro cables...

 

[roadkill]

haha oops thats why you never listen to me if i give you advice

 

[brandoz28]

what cable do you have now?


if its a TORS delete cable it should work fine

 

[Awk08]

i wouldnt go 35 for a non 240 motor, get the 33pwk, and ken oconnor swears the mikuni 34's are much easier to tune than at least the 34 pj's

 

[brandoz28]

i believe there's a 33 in the classifieds right now from a great seller

 

[245stroker]

Alright im deciding with the keihin 35mm pwk QUOTE]

Good call. There are a few people that I know of that run the 35 with a ported stock bore/stroke motor. You'll lose a little low end with the 35 but you'll more then make up for it in the mid/top end

 

[Nativeer3]

I just got stock cable , have not deleted TORS yet though .

 

[brandoz28]

motion pro makes the cable you need

 

[Nativeer3]

Thanks , gotta love these Blastys