ok i read and found that they said its alright to weld on a blaster frame but should i disconnect anything for reasurrence if so what should i disconnect or is it alright to just weld on it
welding
- Thread starter blaster20001
- Start date
I guess it depends on where your welding at. For the most part you can leave everything on. I might get cardboard or something around the area to protect from weld splatter. That way you don't melt plastics or anything.
only thing i would do if you welding on the front end near the electronics is remove the cdi and the rectifyer... anywhere else just clip the ground close to where your wleding
pff what if yu gotta little crack er sumthing you gotta strip the whole thing down then powdercoat it i dont knwo i would probably just unhook the electronics and weld away
IDK man, there was nothing wrong with my frame, but I am taking a break from grinding on it to reply to you. If I was going to weld on a frame, which I had to to add hydro brake mount, and raptor nerf mounts. Then I would go ahead, and add gussets, and powdercoat it. Which is where I am at. It just me though, I tend to overdo things. I'd rather do this now while it is apart, then have it crack later on.
i had to weld a foot peg back on and i welded a hydro mount and i didnt unhook any thing and i didnt fry any thing
i have been welding many yrs tig,mig you name it. as long as you have a good ground and grounded close to your welding you will be fine.
