trottle problems

[03Blaster]

Ok everyone just tried to ride my bike after I installed my vito fat baster pipe and 270 jet. I have vforce 3 reeds timing advance, vitos fat bastard exhaust, k&n it idles perfect but any amount of trottle I give it just bogs really bad and won't rev at all. Any ideas?

 

[CC&Fabb]

TORS still hooked up? If so remove it. If its not check for an air leek somewhere.

 

[tjsdaname]

sounds rich, but the jetting should be right..... so check your TORS and make sure your E-brake is not on lol.....

 

[03Blaster]

Tors is still hooked up. Ran awesome before I put the pipe and swingarm on. Don't have a clue why its doing that

 

[03Blaster]

Don't have ebrake it just won't rev at all

 

[03Blaster]

Also did the same thing with the 230 jet in before I changed it

 

[djack12]

check for an air leak, remove he TORS like mentioned before, and check your compression.

 

[03Blaster]

compression should be good because it ran awesome and fast as hell before i put the pipe and swingarm on. i removed the tors gonna test it tomorrow

 

[03Blaster]

[01:05 AM] 03Blaster: what wires do i jump
[01:04 AM] 03Blaster: then i unplugged the wire from the carb
[01:04 AM] 03Blaster: i took the little red button out of the throttle box and disconnected the other end of that wire under the hood
[01:03 AM] 03Blaster: which freaken wires
[01:03 AM] 03Blaster: ok all i read about this stupid ass tors crap is jump the throttle wires

 

[03Blaster]

Does anyone know what wires I need to jump because I disconnected the tors and bike won't start

 

[newnick]

Once you get it running again check and make sure your getting a good seal between the pipe and cylinder, if its loose you could be sucking in air.

 

[vato87blaster]

jump no wires just unplug al tors components, carb ,throttle ,brain = done