well the guy i got the bike from put too much oil in the blaster and i cant get the drain plug and its to the top of the lil glass window is it bad to run it cus its blowing it out of the crank case vent??
too much oil??
- Thread starter blasterjarred
- Start date
um yes you have to much there. it only should only be about 3/4 up the window. you need to find a way to get that drain plug out and put new oil in. it will work fine then
its new oil only been in for a couple weeks and only drove like 2 times before i noticeds it was blowen out oil
well itd going to be hard to drain just the right amount of oil, but get a factory blaster manual and it will tell you how full it needs to be. you have figure out how to get that plug out.
i just tiped it up on its side and draind a bit out
and checked it and theres lil marks on the lil window to tell u how much u need
and checked it and theres lil marks on the lil window to tell u how much u need
theres 2 plugs to drian oil on the blaster theres another one by the shifter or the break i cant remember what side but its there.
^^ u sure ive never seen another one/heard of it.
yo its 650ml in there. says right on it 650cm3 but same as mL.
yo its 650ml in there. says right on it 650cm3 but same as mL.
this would happen to me to yo. its a tube that goes all the way up to your top part of the frame and when it has too much oil it leaks it out and it start blowing from the front. I thought it was the cylinder leaking or the front brake lines but when the piston blew and i stripped the whole thing i found this tube that was at the top and lead to the bottom end of the engine. thats why it blows from the top
