Throttle issues

[Beatingu01]

I purchased an 01 blaster it's bone stock it won't idle so I tried adjusting the idle screw on the tors system but it just turns and turns either direction so I gave up now when I start it the throttle is extremely sensitive and sticking wide open when I give it gas I also tried unplugging all of the tors wiring with the same result any help is greatly appreciated thank you

 

[blasterdemon7]

The first thing is to take the carb apart and clean it good. You may also need to replace the cable do to wear and stretch.

 

[Beatingu01]

Ok thank you I'm new to blasters it ran great before I tried to adjust the screw do you think I stretched the cable by turning the scew too far?

 

[lofosho97]

Turning the idle screw wouldn't have stretched the cable. Make sure the routing of the throttle cable is correct. If it isn't it could be getting pinched or its just bent wrong and the cable itself can't slide easily inside the insulation. If its routed wrong it can do funny things like accelerate for you when you turn. Disconnect the cable from the thumb trigger and move it manually to see if it sticks or binds.

 

[Beatingu01]

I just went out and adjusted the slack out of the cable and now it appears to so fine thanks for all the help

 

[lofosho97]

No problem. Glad it worked out.