Swingarm

[jays blaster]

Here's what I have. There is seals to the inside, a spacer in the arm and bearings to the outside that's it

 

[jays blaster]

Here's a close up of the inside

 

[slickerthanyou]

oooooooh shiny new parts hellz ya!

 

[jays blaster]

Here's one of the outside

 

[jays blaster]

Don't know if this helps but here another one

 

[jays blaster]

Here it is from the rear

 

[slickerthanyou]

Don't know if this helps but here another one

Now that is so shiny i can't see it! I:I

 

[sicivicdude]

One of the swingarm rebuild kits would get you a LONG way towards getting it together. It looks like it has the needle bearing, bushing, and seal.

You are missing the hardened pivot tube and grease seal/caps and of course the pivot bolt and nut.

The pivot bolt and nut can either be purchased used or new OEM. An AllBalls swingarm bearing kit will include the hardened pivot tube and grease seal/caps brand new. Throw the bearings, bushings, and seals on the shelf for later!

 

[jays blaster]

Is there any spacers or anything that go to the outside of the swingarm

 

[sicivicdude]

Is there any spacers or anything that go to the outside of the swingarm

There is a funky little ring that slides over the tube and the chain roller on the chain drive side.

The "left" side just has the "cap" with the grease seal inside. The cap for both sides would be included in a bearing kit or you can order it piece by piece OEM.

 

[jays blaster]

Thanks for your help... I think I need a manual too

 

[sicivicdude]

http://www.blasterforum.com/general-support-17/downloadable-yamaha-blaster-manual-17325/