stator cut a lil

[blasterjarred]

well my blaster isnt running good and me and some ppl on here have decited its a eltrical prob and i finaly got my flywheel off thanks to a friend and his flywheel puller well i noticed after i cleened all the white sh*t off of it that theres a lil gash that cut threw the plastic layer on the coil and got some of the copper wire but not too much is this the reason y its not running becose it ran for a long time before i noticed it just resontly its been messen up

 

[blasterjarred]

i filled in the gash with soder and in the prosses of sarten it up it rand for a sec then died and i sheard the flywheel key so gota get another and try agan

 

[89custom]

its wound in a coil for a reason. if you filled it with solder its not going to work. you need a new one.

 

[blaster20001]

ya id say replace it

 

[blasterjarred]

ok hopefuly i can get one on ebay for a good price

 

[BlasterSPL]

Ya good luck i dont buy anything off ebay anymore..Been ripped off 3 times and you try to give people benefit of the doubt but you still get sh*t on..Anyways just get one from Yamaha..I know there expensive but in the long run you will not regret it..Also that wire on the stator is insulated so that is prolly your problem..Good Luck!! Kurt

 

[quam]

yup, if you soldered it, you ruined it.
i might have one tonight that i can sell ya....i'm buying a bottom end from someone off craigslist and he says that all the electronics are included.
if the stator is in there, i'll sell it to ya......