So I recently bought this blaster. Was told all I needed to do was to replace the clutch hub so I did. Made sure everything where it was supposed to be. Now I got it up to the starting point. The Quad revs when it's idled slowly but when op it wants to die out. I removed the tors and still have that issue. Then to top it off when I put it in gear the bike won't rev and shuts off.
Starts shifts but turns off.
- Thread starter AtvRider559
- Start date
did you adjust the clutch pushrod at all? or just slap the clutch together and pray for a miracle?
I do recall putting the original back in Checked today and the clutch rod was broken and the clutch ball was half way gone obviously this is a problem but how can this be the cause of my issue?
well that push rod and ball are very important in the function of this clutch. If they are broken, the clutch will not work properly. I would suggest replacing both the clutch and rod ball, then properly adjusting them before trying to ride again. Im guessing that since the clutch is not properly adjusted, when you pull the clutch, its not disengaging all the way and when you shift into gear you are basically stalling the bike.
I bet if you rev the bike real high before you pop it in gear it will throw you off the back lol
I agree with buckster, its probably stalling because the clutch isn't disengaged fully.
I agree with buckster, its probably stalling because the clutch isn't disengaged fully.
Last edited:
Similar threads
