Sprocket replacement help...

[Street2uned]

Alright, I got my 14 tooth front sprocket in the mail today and ran out to swap it with the stocker. Getting the stock one off was a little bit of a pain...but not too bad. I figured I could do it without removing the chain...

So the 14t sprocket won't just slip right in like I had imagined. I can't seem to get the stock one back on either. I understand that I need to loosen the rear hub bolt, but they don't want to budge. Is there any tricks or ideas that anyone has to help me out?

I found the master link on the chain and removed it, but still had no luck getting the chain apart.

Is the stock chain going to fit with the 14t sprocket?

 

[98blaster+4]

yes it will fit but you are going to need to get the chain master link separated. to loosen the rear bolts try spraying some lubricant on them and letting them sit for awhile. i like to use gun oil for the tough ones

 

[Street2uned]

Thanks man. I just found another thread in the general support section and found some good tips too. I'll give those a try, but I'll keep an eye out for any more help. Thanks again.

 

[Street2uned]

I got that bastard on! Once I broke loose the lower rear hub bolt, it moved a little. Superman must've tightened the top bolt, but all 150lbs of my ass managed to break it loose. Thanks for the help and the advice I found in the thread in the general support section.