Speedlinez install

[slickerthanyou]

My speedlinz installed ready to ride!

From the master - Still may adjust this not sure if I want it pointed down or up...

Splitter attached for now- Making a stainless mount much smaller Wish i would of just bought the two long linesinstead but oh well... -

R side with clamps-Love thos clamps but expensive-

L side with clamps-

With the hood on-Hidden out of side almost-

 

[Blaner]

very smart1515151

 

[Surfrjag]

nice! i bet you can stop on a dime... whats that container on the front of you bike for?

 

[slickerthanyou]

nice! i bet you can stop on a dime... whats that container on the front of you bike for?

Nitrous BOOST, Nah, It's my tool carrier, I stole I mean borrowed a O2 cylinder from work, that bad boy is 1/4 inch aluminum!


Thanks Guys

 

[Awk08]

lines look good bob, now lose that moto tassanari decal on the tool box,
heres the new rad valve decal....................

 

[bagds101]

looks good. i wanted to get those clamps for mine, but theyre a little bit pricey for clamps. ill just use zip ties for now

 

[slickerthanyou]

lines look good bob, now lose that moto tassanari decal on the tool box, hahahaaa

Haaaa, I was waiting for someone to point that out! Ya I need to re-label
my sh*t!

 

[norman420]

Were those the lengths suggested for stock Blaster A-Arms?

N

 

[slickerthanyou]

Yes. I just couldn't put those rubber lines on that awesome setup!