some help if u gota min

[hudack]

allright well my blaster wont idle at all it was realy not a big deal at all at first cause just give it a little gas but when i got warm it up at night if i put it away then i gota sit there and hit that gas so i gota push it up a big hill cause my neighbiors got a baby and im not the type of person to wake someones baby up at like 9 at night and itd be nice to be able to step away from the quad without it dying

 

[yb200]

did you adjust the idle under the seat.....or tinker with the air screw

 

[4cfed]

soo.... turn your idle up.... big screw on the top of the tors brain under the seat... or the screw on the side of the carb, or turn the throttle cable adjuster...

 

[hudack]

yea i tyred the idle but it didnt do the trick i havent messed with the fuel air screw yet the carb came off my bros blaster cause it was just rebuilt and cleaned and all that an his didnt run so i took it along with the new top end that had no hours or minuets on it lol cause after it was rebultl it still wouldnt run but his would idle so idk wats up with that

 

[stephen12091985]

you can adjust the cable on top of the carb if theres is not tors. but this isnt the right way just temporary

 

[hudack]

ill have to try that but i think my bro allready did and it didnt work but not sure im gana try the fuel air screw to see if any of this works this is gana be a dumb ? but where is the fuel air screw at i never realy messed with carbs that much

 

[Awk08]

small brass screw on shifter side of carb right near were the fuel line goes in, supposed to be 1 1/2 turns out from the bottom, then turn it slowly out at first till you get the highest idle, shouldnt be more than 3 turns out, then adjust idle with the idle screw under the seat

 

[super noober]

pilot jet!! take it out and clean it.

 

[Tim Lutz]

You can also try unplugging the TORS at the throttle, carb and control box. This has cured the problem on other blasters.

 

[hudack]

the jets and everything are brand new i still gota do a plug chop to see if its runin right like i said the carbs off my bros and it was rebuilt and cleaned and all that and hadnt been used til i put it on mine cause his is after market and i was told that that was my idle screw cause it dont have the tors on it but they could be wrong but then where would my idle be