So this is what I have to work with

[2000blasternewb]

Finally took some pictures of my carb. Obviously its a Keihin, not sure on the size. I didn't have any way of measuring it. It's also a PWK carb. I don't know anything about these. There was an AB145 main jet and a 45 pilot jet sitting in there. Are these going to work well with a stock bore and a full exhaust?

 

[yb200]

most likely a 35mm

 

[mr_3_0_5]

probably too much carb for a stock bike. put a regular tape on it. my guess is its a 36mm

 

[2000blasternewb]

what do you mean by regular tape?

 

[mr_3_0_5]

regular tape measure.

 

[yb200]

measure it with a tape measure

 

[2000blasternewb]

ohhhh ok lol. do you think i will be able to use this carb still? can i just put different size jets in it?
do you think that the pilot jet is to big? what about the main jet?

 

[yb200]

if you port it will work nice

 

[2000blasternewb]

im not goin to right now. my lil brother said that its fine for him just about stock. what if i just put some different jets in it? also why would there be such a small main jet?

 

[yb200]

keihin jets are numbered diff

 

[2000blasternewb]

hmmmm so what should i do to find out what sizes i should use?

 

[yb200]

pm kennedy he should have some good info for ya

 

[jbblaster]

how did you get it to fit in the intake boot?

 

[jfblasterboy65]

hes got a clamp on for the filter... and he either dremeled out his stock boot or got a new one for a bigger carb

 

[blasterfreek30]

thats a stock intake newb, check to see if its dremmeled out, if its not, than most likely its a 28mm