rev/idle help..

[kissiimack]

the engine seems to rev up by itself (only in neutral or when i pull the clutch in) after a little bit of hard riding. i dont think its an idle problem because the quad idles fine when i first start it. But after riding it will rev up in nuetral. is this normal? i have two blasters one that completly stock and one that isnt but they both do the same thing. anyone know what it could be?

 

[mr_3_0_5]

i would turn you air mixture screw in just a touch till you get the idle you want.. i set mine up to idle good after being ran..

 

[kissiimack]

which one is the air mixture screw? ive only been riding for about a month and know nothing about quads

 

[mr_3_0_5]

which one is the air mixture screw? ive only been riding for about a month and know nothing about quads

Turn this a quarter turn at a time...you can fine tune on top of the tors

 

[kissiimack]

alright i'll give it a try when i get home, thank bro

 

[kissiimack]

i played around with that thing and no change..anyother ideas??

 

[blasterman87]

how much gas is in your tanks?

 

[kissiimack]

i usually wont let it run under a quarter

 

[Dtrap]

Could be your Tors or an air leak some where? The TORS are notorious for causing problems like this. Most just disconnect the tors. There is a thread that tells you how to do it on this site.

 

[kissiimack]

someone suggested it could be a floater issue anyone know anything about that?

 

[skoobyj]

I have 2 blasters one stock and one heavily modded and they both do the same thing your talking about. I have tried everything including disconnecting the tors fine tuning the air and idle screws, checked every inch of the case and all gaskets for air leaks and I can't do anything about it. starts and idles fine but after it gets hot and I have been riding hard it never fails it always revs high in N or when I pull the clutch. I have just learned to live with it.

 

[kissiimack]

as long as my motor doesnt blow i dont care..i just want to blowq my ported head

 

[skoobyj]

It doesn't rev that high does it? Mine rev high but not high enough to damage anything.

 

[kissiimack]

it doesnt sound to to bad but it doesnt sound good..idk man some kid said my floater was too high whatever than means..

 

[battbike]

try adjusting the throttle cable on the thumb throttle housing. screwing it in it should rev down, go a litte bit at a time.

 

[kissiimack]

it idles fine when i first start it up so i dont think its the throttle cable..i'll try it out though and see if it helps.

 

[battbike]

any luck with the idling problem?

 

[kissiimack]

i havent done anthing with it yet..there is about a foot of snow outside im waiting for the strom to end maybe i'll ride a little tonight and then tweek it

 

[robert0762]

Mine does the same thing .You just have to play with the adjustment of the idle screw .Sometimes i turn it down after i been riding but i have the idle pretty low on start up so once it does warm up its just about perfect

 

[kissiimack]

i tried that already it didnt work..i had my idle so low at one point the quad couldnt idle when i first started it and it still did the same sh*t when i rode..its weird..i almost want to try jetting another carb for it but i dont feel like doing all that work

Mine does the same thing .You just have to play with the adjustment of the idle screw .Sometimes i turn it down after i been riding but i have the idle pretty low on start up so once it does warm up its just about perfect