replaced broken reeds still wont start??

[little3mil]

last time I was riding I was tacked in 6th and it died on me. I thought I blew the rings untill I saw I broke a reed (stock) so I got vforce3's installed them but still wont kick start? Now I've got some spark but it wasent real bright, like it may be weak. also I can now push the kick starter easily with my hand and feels like no compression but the day it sh*t out it had good hard kick to it and was running fine all day until this? tonight I will get a comp tester and see but could my stator have gone too? :-/ Will an auto zone flywheel puller work? tors is removed

 

[yb200]

deff check the compression anything under 100 is not good......here is the fly wheel puller you need:

BANSHEE BLASTER LT500 LT250 QUADRACER FLYWHEEL PULLER:eBay Motors (item 370269812047 end time Nov-02-09 19:06:50 PST)

 

[little3mil]

ok so i do need the ebay puller. I'll check compression tonight and see what I come up with.

 

[yb200]

right on................

 

[J4M1E333]

have you installed the reeds correctly? the reeds also contribute to the pressure in the cylinder, also, i wouldn't worry about the spark concentrate on getting compression.

 

[2strokepower]

wow i hope i dont have this problem when i install my new reeds.how did this happen to both of us on the same day, at the same riding spot???

 

[2strokepower]

yay tested my bike today and it runs mint againI:I

 

[little3mil]

yay tested my bike today and it runs mint againI:I

dam your lucky, can't say the same I tore down the motor cause i knew there was no compression i didnt even need to test it, anyway I blew the PISS outta my top end heres some pics. Atleast i got to drink some beer and work on her although it only took 30 mins to get the cyl and piston off... HAHA I must have leaned it out because it was 50 degrees out! (instead of 91 degrees in fl) Does anyone know where I can send the cyl to be bore/honed??



http://i33.tinypic.com/2r3jibq.jpg

http://i38.tinypic.com/206mmv6.jpg

http://i36.tinypic.com/2rrwjzl.jpg

http://i35.tinypic.com/2a5lnhc.jpg

 

[J4M1E333]

Damn! i'd say you leaned it out to be fair!

 

[little3mil]

Damn! i'd say you leaned it out to be fair!

almost burnt a hole in the piston!!!! I:I B)

 

[J4M1E333]

ye, near enough, when you doing the rebuild?

 

[little3mil]

Im starting this weekend if all my sh*t comes in, should be easy looks like a huge goped motor!!

 

[yamahaman126]

Call Jeff @ FAST. He is the man!

F.A.S.T RACING