removing blaster hub from a lower a arms

[atvracer7]

how do i remove the hub from the lower a arm like the ball joint part because it wont come off i have the brake line off and the upper a arm part off i just cant get the lower a arm to get off hub

 

[yb200]

a mallet and some pataince spl.......dont f-up the threads

 

[atvracer7]

thanks dude and i am putting new a arms on but i will still make sure i dont f up the threads

 

[sc0r1a]

unscrew the nut till the top is even with the bolt and smack it with a mallet.
If you dont have a rubber mallet try placing a piece of wood over the nut then beat it with a hammer.

 

[blasterdemon7]

atvracer7.Whats up with the contest your in?Any new info?

 

[R2F]

How about don't hit the bolt at all. Turn the steerin knuckle as far as you can with a small steel hammer smack the side of the knuckle where the ball joint bolt goes through this should release the bolt.

 

[matt75]

Or how about do it the right way and put a gear puller on it. Thats why the spindle is recessed on the end of the threads, for the puller.

 

[R2F]

I thought he is trying to get the lower ball joint out of the knuckle?

 

[yb200]

he is removing the balljoint from the spindle

 

[atvracer7]

hey guys i got it and as for the contest dakota demon i am beating everyone so far and i figured out that eachday you can vote 1 time

 

[R2F]

he is removing the balljoint from the spindle

That is the same thing as the knuckle. Spindle is for the hub knuckle is for the steering but its all one piece