I was wondering with an aggressive trail port and a fat bastard pipe would a reed spacer still shift the hp curve a little more towards the lower end?
reed spacer ?
- Thread starter Troyaughenbaugh
- Start date
not to sure if it makes a diffrence but, ive heard by putting the spacer before or after the reeds will change that
this is to yb200. What type of porting did you get from kennedy? Do you like it and is it a big difference from stock? I know you are already running a shearer pipe, I believe.:-/
i have not had it out yet i am still putting my bike together....but he tells me 32-34 hp is what i will be putting out....stock i believe is 16hp so double the hp not bad for the little money its cost for a port job...and i am runninh the toomey b1 pipe
Are you going to post a review when you get it all together? When do you think you will get it together? I'm curious to see how your's turned out to see what kind of porting I want. That's what the forum is all about, right? And also, what type of port did you get?
i got the trail port and redesigned head..and yes i will post up a good review but it will prolly be in the spring
Most larger than stock carbs need a reed spacer to clear the clutch arm.The only reason you should run one.Very little gain.IMO I could have turned the carb on mine but the carb was sitting at too much of an angle.
My recently acquired blaster came with one before the reed cage so i plan to use it.Ive replaced the stock reeds with BOYSEN power reeds any draw backs or problems doing this?
Plus its chrome plated so of course its going to add to the "BLING BLING" factor!LOL
Plus its chrome plated so of course its going to add to the "BLING BLING" factor!LOL
Similar threads
