I heard a while ago the mounts were similar. Has anyone ever heard of this? can it be done with enough fab work?
anyone here with a raptor 350?
Thanks
anyone here with a raptor 350?
Thanks
Raptor 350 plastics
- Thread starter Blasterdude27
- Start date
Anything can be done. Id buy them and mod them up. If anything you will just need to drill a hole in the plastic, and trim them a tad bit.
True. I was thinking about useing the raptor seat.
Btw. did you ever get your 700r rear fender on?
somewhat i had the other one off and was eyein this one up i dont think it will be much work. all i have to do is finish this air box and put the fender on. i thought about using a diferent seat, but they dont have the same front. its skinnier and it wont match up to the tank.
Well guys anything can be done and the rear is probably the easier of the two to accomplish, you have to remember that the raptor 350 has the same frame as a warrior with minor differences. You will definately need a Raptor gas tank and seat assembly. As well as fab up fender stays for the rear, the raptor 350 uses its grab bar to support the rear plastics.
good luck though
good luck though
alright thanks. if anyone can give any more info that would be great.
or if anyone can suggest something else.
or if anyone can suggest something else.
I have a Raptor 350, but my wife would seriously oppose cutting it up to test fit it to a Blaster.
hey im thinking of puttin the raptor front plactic on my blasty. just cut the fender how the blastys are drill the holes and put em on.i just need to buy the plastics.
Cool I hope it works out for youB-) I've got a few different ideas going so I might not have raptor plastics on this blaster, but I'd love to try it on another blaster someday.
Similar threads
