I cant seem to get this blaster to run right i pull the choke all the way out and it starts for a few seconds then dies and it wont start again the only thing that i have done to it recently is do the oil injection block off and remove the tors and i put the intake boot on correctly the funny thing is when i got it the thing would start fine and everything was out of place the intake boot wasnt on and the carb didnt have any lines only the drain one im pre mixing my gas at 40:1 and suggestions?
Problem with starting need help
- Thread starter TXBLASTER
- Start date
at least you know what you changed to cause the problem so go through everything you changed and make sure it is done properly. sounds like you might be gettin too much air. so an airleak somewhere possibly. hard to tell from my house
