Primary gear dimension Q.

[kx3]

What is the dimension of the primary gear on a Blaster?

Number of tooth.

Width.

Height.

Diameter.


Thanks! I'm trying to find solutions to fit mt +3 Vitos on my DT200R.

 

[hotrodaj_2]

I'm a little lost. Are you looking for the transmission gear size?

 

[kx3]

I'm a little lost. Are you looking for the transmission gear size?

I'm after the primary drive size. i.e. the gear that is mounted on the cranshaft.

 

[hotrodaj_2]

Oh, ok. Sorry, I cant help you. I have not got into my bottom end yet. I'm sure someone can help you on this forum.

 

[slickerthanyou]

I'm after the primary drive size. i.e. the gear that is mounted on the cranshaft.

If ya don't have an answer before i get home i'll let ya know I know that someone on here knows off of memory.

 

[kx3]

If ya don't have an answer before i get home i'll let ya know I know that someone on here knows off of memory.

fine! let me know if you find out.

I'd really like to use this +3 Vitos crank. A customised gear would cost me 330$ for the first unit but the crank is about 150$ cheaper than OEM!
On the long run, it would be cheaper

 

[slickerthanyou]

I have two spare gears at home. I'd send ya one if ya need it. I'll be home in two hours-

 

[kx3]

I have two spare gears at home. I'd send ya one if ya need it. I'll be home in two hours-

width has to be 28mm...

 

[slickerthanyou]

What is the dimension of the primary gear on a Blaster?

Number of tooth.

Width.

Height.

Diameter.


Thanks! I'm trying to find solutions to fit mt +3 Vitos on my DT200R.

Ok bro i got-

22 teeth

19mm wide

Height is 4cm (same as diameter)

Diameter is 4cm . a few pics too...

 

[kx3]

Even if I don't like the answer, (I'll have to make my own gear) thanks a lot!