Oil Injection Block Off Question!!!

[RJR677]

I'm confused. At the risk of sounding like a total noob. The blaster is a 2-stroke...I know this. is it factory oil injected? If not, what does the Oil Block off kit do? I'm really sorry about this stupid quesion...but I do not have an oil tank on my Blaster. Could the block off already have been performed?? I know the motor was rebuilt do to a lock up. Help!

 

[coreyownz]

just make sure you keep premixing...

 

[RJR677]

so chances are the oil block off was already performed??

 

[powercrazy3]

sounds like it to me

 

[Unstock240]

Just unscrew the plastic cover on the right side. The one with 4 Philips or whatever, and see whats underneath. If there is a pump or flat plate or something with no hoses. About a 1 minute job.

 

[chuck_neste]

I bought a blaster and I removed the white nylon gear for the injector, Grinded down the teeth on a grinder and then reinstalled. The injector was already missing. How does the injector normally work. I have a carb that has gas, spark and it wont start. Tors has been eliminated . Any thoughts? mixture is 32:1 May start with starting fluid ( I know its bad)

 

[Rease3]

what is good way to get the spacer out of the hole to install the plate?

 

[Unstock240]

pliers or vice grips will do it, its not in very tight. Watch though it only goes out one way I don't remember from the front or back though.

 

[blasterkid114]

I'm confused. At the risk of sounding like a total noob. The blaster is a 2-stroke...I know this. is it factory oil injected? If not, what does the Oil Block off kit do? I'm really sorry about this stupid quesion...but I do not have an oil tank on my Blaster. Could the block off already have been performed?? I know the motor was rebuilt do to a lock up. Help!

the answer is yes they were oil injected and the block off kit had to be performed if your premixing now. the bracket should probably still be there for the oil resivour.