Oil Block off?

[Juggaloclownz187]

Hey guys dumb question time again....

The guy i got the bike from said it was "blocked off" but when i opened black cover the autolube pump was still there, how else can i see if its really blocked off or not?

I did not see any oil bottle but that does not mean it was just removed, want to make sure it was blocked off properly before i fire it up when the piston gets here

 

[fioz600r]

Hey guys dumb question time again....

The guy i got the bike from said it was "blocked off" but when i opened black cover the autolube pump was still there, how else can i see if its really blocked off or not?

I did not see any oil bottle but that does not mean it was just removed, want to make sure it was blocked off properly before i fire it up when the piston gets here

Its not blocked off it just sound like it is disconnected. there is a white plastic gear behind the pump that you should make sure is off.

To do it right you should remove the pump and cover the hole that goes through the cover.

 

[fioz600r]

Here is a pic of what the block off looks like it is the metal cover where the oil pump went.

 

[Juggaloclownz187]

Thanks alot guys, really appreciate it!!!!!

Guess it doesn't really matter since the scumbag piece of sh*t that i got the machine from neglected to tell me there was 2 holes in the left crankcase that i did not notice until today after i just dropped $300 in parts.... Now im broke and the parts for the motor are no good since i cant afford to fix this one now im really f***ing pissed!!

Looks like im taking a road trip to beat some ass! X(X(X(X(

 

[2strokesmoke]

that realy sucks, polish up the bat mate!!

 

[fioz600r]

You coul always JB Weld the case

 

[Juggaloclownz187]

Here is what i have, 2 seperate holes in the same case, one on the front one on the top.... Let me know what ya'll think of it.... Thanks, im soooo ticked right now!
X(

 

[Juggaloclownz187]

Thats not a good place for holes correct??

 

[TeamCarr]

i would work a week and get on craiglook or ebay or this site and try and find a cheap case or old bottom end someone has just laying around. you would be amazed at what kinda deals you can find and how many people will actually help someone out. those holes look terrible im not gonna lie. they are huge and any hole in your case is in a bad place.

 

[Juggaloclownz187]

Bummer X(

Yeah i found 2 motors there both 2 hours from my house, a little farther then i want to drive if i dont have too and there also expensive....

I just want to either bolt on a new running motor or just a bottom end, not really wanting to split cases or anything like that, it still needs a top end anyhow.... X(

Im depressed now :-(

 

[Juggaloclownz187]

Any ideas on what could have caused this? I got all the old piston peices out of the crankcase and it turns over good now, crank moves good etc etc....

 

[fioz600r]

Wow you cant JB Weld those holes...

 

[Juggaloclownz187]

What the hell could this moron have done to make these holes?