new oko 28mm flatslide

[roadkill]

today i finally got my my new carb on and i dialed in the main after the the 140 i tried had no mid power and put in a 138 and it has a load of high rmp power but not that much mid and has a lot of low just not much mid and when the powerband hits i doesnt kinda slide into it like it used to it hits really hard now and brings the front wheels up, i was just wondering if it should do this or if i might be off with my jetting somewhere, i did a plug chop and the 138 was just right, but it needs more mid any ideas?

 

[acezeesawtooth]

needle clip? and pilot?

 

[roadkill]

where should i move the needle to? and i dont think its the pilot because it works fine in that area

 

[roadkill]

and when i say no power in the mid i mean mid rpms like if i hit the throttle and it isnt in the power band it slowly gets more power as it get in higher rpms but when it hit the powerband it hits it really hard now, but it seems it has less mid than with the stock carb and its harder to keep it in the powerband

 

[roadkill]

anyone have an idea?

 

[pittboss45]

No lid on the box and a 138, you are too small.

 

[roadkill]

i had a 140 in there and it was too rich, when i put a new plug in with the 138 it ran a lot better and gave it more mid, and the plug looked perfect, do you think it would help if i went richer?

 

[roadkill]

anyone?..........................................

 

[Demo4o1]

reeds? better yet just sell it me I:I

 

[roadkill]

would reeds cause it to act like this? my reeds are in pretty bad shape right now with like 1/8 to 1/4 gap im surprised they are still working im gonna buy some new ones after my birthday when i have some money to spend

 

[Demo4o1]

Oh yea reeds could cuase that. Just take the carb off and poke ur finger in the boot to feel if its cracked or loose. If its bad in the 1st place u shoulda replaced them