new axle for my blaster

[slickerthanyou]

It fits in very well
only the right side/ the right wheel is about 0.5-1cm wider than the left side )=

HMMM, I just checked and 660R is the same as blasters and banshees! It's the 700 that is different!

Maybe shim with washers the otherside? or that may not leave enough threads???


BTW if your measuring from the shock out The shock is off center 1" from factory so one side is longer than the other, But take a look at the quad from the front and i bet it will be right on!

 

[germanblaster]

i measured from the footbars from the plastics and some other ponts
when im standing in front or behind the blaster i can notice that one rear is wider without measuring

are the two points where the carrier attached to the swingarm in center?


here are som pics but on the pics it seems to be in equal length but in real it is not!







I think the 660er has the axle nut on the right side ?
Maybe i would get in in equal length within rotating the axle so that the axle nut is on the right side, too?!?

Another possibility is to get in equal wide within putting one more distance ring on the left side.

( The axle comes with 6 distance rings -4x 1cm , 2x 0,5cm

Currently i have two distance rings on each side
when im going to add the the 0,5cm distance ring on the left side it should be equal wide but that is not the best solution in my opinion

Has anybody of you the same problem before?

 

[Larry's Shee]

Do both rear wheels have valve stem same way?

 

[germanblaster]

yes both valve stems are on the outside
do you think rotating the axle would help or would that be wasted time=?

 

[slickerthanyou]

yes both valve stems are on the outside
do you think rotating the axle would help or would that be wasted time=?

Pretty sure that the axle will only work one way on the blasty! maybe someone else will chime in.

 

[germanblaster]

i think i have to go and measure the brake und sprocket hubs ?!
when the sprocket hub is shorter than the brake hub , rotating will make it equal wide?!
Does anyone know whether the carrier ends are identic off center?
I remember that one end of the carrier is a bit off center?!?!

on this picture you can see that one side is more wider....
http://i53.tinypic.com/jjn3vr.jpg