Need help guys

[Aaron renter]

Hey guys i need help i just recently bout a blaster n the case craccked so i put a new boltn go 200 engine in it and bout new carb reeds. n put it all together n it starts but idles rough n when u hit the throttle it wants to open up but it just bogs down n dies. took out the spark plug n it was black n gummy any ideas how to fix?

 

[blastermaster01]

sounds like your TORS and/or you're running rich.

 

[Aaron renter]

how do i go about unhooking the tors and how do i adjust from running to rich?

 

[fioz600r]

Welcome to the site............

As for removing the T.O.R.S. check out the DYI section there is a thread in there that will help you out. You can also buy a T.O.R.S. Deletion kit from eBay. There is a Motion Pro kit and a Vitos kit. Make sure you get the kit with the new idle screw.

 

[blasterdemon7]

Welcome to the forum.

 

[stephen12091985]

you change your jets to get it from being to rich.

 

[Aaron renter]

okay guys thanks for the help i umhooked the tors n it worked but i have only half power that i should any ideas on how to fix?

 

[3 Wh33l3r Rid3r]

mine was doing the same thing when i bought mine after i took the tors off i took the airbox lid off and holy sheot she rolled out but my jetting was off put the lid back on same crap took the little snorkel piece of the front of the airbox and she runs like a raped ape guess mine wasnt gettin enuff air with it on worked for me

 

[Aaron renter]

hey thanks man that was a good call took the snorkel piece off n run good now just have to adjust the jet now thank again guys