What are some good motors to put into a Blaster that don't need mager fabing?I see a lot of cheap dirt bike motors for sale.
Motor swop
- Thread starter blasterdemon7
- Start date
CBR 600's are apparently not that much custom fabs. Just make sure you do your research before you commit.
Easiest would be a yz400 or 465, there basically a much bigger baster motor.
But nothings ever easy or cheap, and its a big project no matter what.
But nothings ever easy or cheap, and its a big project no matter what.
Any other motor that you go with that isn't the stock motor will need the same thing:
New motor mounts
A custom pipe- 2 stroke especially!
New carb
New electronics
Don't forget the old aircooled dirtbike motors are antiques.
Might look cheap but you will have to rebuild them.
A water cooled motor is gonna need a radiator.
CR500's and 490's are almost unreadable in a quad frame from vibration.
New motor mounts
A custom pipe- 2 stroke especially!
New carb
New electronics
Don't forget the old aircooled dirtbike motors are antiques.
Might look cheap but you will have to rebuild them.
A water cooled motor is gonna need a radiator.
CR500's and 490's are almost unreadable in a quad frame from vibration.
Back about 4 months ago .I seen a Blaster for sale here in Delaware with a GSXR 1100 motor on it.
hey dakota just so ya know , that pipe im sellin ya will work very well with just about any mods you do to the stock motor.
i think you would do good with a port/ polish, bigger carb, better reeds, and maybe a stroker. just my opinion. you can get alot of power out of these little 200's, just gotta build em up
i think you would do good with a port/ polish, bigger carb, better reeds, and maybe a stroker. just my opinion. you can get alot of power out of these little 200's, just gotta build em up
I don't plan on swapping motors in this Blaster.Just wanted to know so if I wanted to do it to a blaster later down the road.
