i noticed on my blasty when i got it back from the dealership that the head stud,one is shorter than the other three and they put cheap nuts on also(on base nuts too)so im ordering the oem studs from rockymountain and since i will have the cylinder and head off what gaskets should i get too?i remember reading here some were not as good as others.also how hard is it to change out the studs?
motor studs
- Thread starter beaten blaster
- Start date
You want to use OEM or comedic brand gaskets. It's not hard to remove studs. You put two nuts on a stud . Use a wrench on both and tighten the top one while loosening the bottom one till they jam tight together. Use one wrench in the middle of the two to loosen it. Sometimes that doesn't work out and you have to hold the top nut while turning the bottom one to screw the stud out.
