Light Switch wiring.

[DReeds]

Hello everyone...recently bought an 03 blaster and the previous owner had redon the wire harness and didnt connect the head light..well long story short i want to connect it..i have a multi switch that i want to use bc he got ride of the light swith and installed a kill..

i have this kinda switch...no what do i run it to tho,as in the wire colors..i know black is ground but whats pos and neg??
also on the back of the light is a YELLOW..GREEN...BLACK wires.
http://img.alibaba.com/photo/230643299/KCD1_105C2_12V_DC_DOT_LED_SPST_Rocker_Switch_Car_Boat.jpg

Thanks in advance for anyone that can help me out.

 

[DReeds]

helpity help help helppppp..lol

 

[blasterracer817]

idk if thatll work a 3 way dpdt swich i think it is will prolly be the best u will havelow and haigh and off and alot more easyer cuz it has enough prongs for everything lol

 

[DReeds]

it will work off the 3way switch,my bros blaster is wired like that buttttt he lives in FL and on Vacation right now so i cant ask him...sucks i know..lol

 

[yb200]

use the yellow/red wire from the stator for the power to the switch.....then run the back wire on the light to a bolt on the frame and use either the yellow or green to the other side of the switch high or low beam...cant remember what is what....or get a 3 way switch and hook the yellow/red stator wire in as your 12v source and the yellow and greens wires off the lit to the other 2 prongs for high and low beam

 

[blasterracer817]

thats what i was talkin about but i dint know hwt wires

 

[DReeds]

im just gonna use high beam,no point in low beam..lol

ok so:

Y/R= Pos {+}
Yellow=Hi {+}
Black=Ground. {-}

 

[yb200]

im just gonna use high beam,no point in low beam..lol

ok so:

Y/R= Pos {+}
Yellow=Hi {+}
Black=Ground. {-}

that is correct and yes yellow is high beam

 

[DReeds]

that is correct and yes yellow is high beam

thank ya sir...i figured that,i was is looking at the scmatic i have,but i needed to make sure.lol Rep points for ya.

 

[yb200]

no pob bob........

 

[DReeds]

can i run it like this??

 

[DReeds]

yes no maybe?? lol

 

[DReeds]

bumppp wanna know if that will work asap.

 

[J4M1E333]

yeah i think that will work, just dont seal anything til you know it works, if i were you aswell id use a low beam i know it sounds stupid but high beam disperses the light quite high and makes whats infront of you dimmer, i use both quite a lot but that just my 0.2 I:I

Welcome to the forum aswell!!

 

[yb200]

this is the right way you want to do this