leaking

[newtoyamaha2121]

hi im back the current issue is when i turn on the gas nothing happens but when i ty to kick it a couple of times it pours out the little hose on the back of the carb any ideas please reply quick

 

[blasterkid1994]

stuck float? 151515

 

[DUALSTROKE]

It could be sticking floats but usually that symptom will happen when sitting there.I would also check your needle and seat.Mine as well take the carb apart,make sure the floats are working.Set the float height,check the needle and seat,and a good cleaning,etc.

 

[newtoyamaha2121]

im new to engine work could i get possible walk thru

 

[mud runner]

the float may be cracked

 

[DUALSTROKE]

See if these will help you.

http://www.blasterforum.com/carburetor-138/float-heights-how-adjust-them-50565/

http://www.blasterforum.com/do-yourself-20/easy-almost-free-way-stop-leaky-carbs-33335/

 

[newtoyamaha2121]

how do i check the float

 

[mud runner]

put the float in a bowl of water and if it floats its good if it sinks its bad

 

[Blaaster]

/\ /\ /\ /\ Thats a bit extreme, give it a good shaking you will hear if there is fuel inside.

 

[newtoyamaha2121]

i got it started but will only take gas when choke is out it will idle with choke in but cant rev it sjust bogs down

 

[Larry's Shee]

If it's very cold where you are goy to let it warm up a bit. Also need to start searching , there is a download manual on here, as well as carb cleaning/repair threads.

Let me google that for you

Let me google that for you

I:I

 

[newtoyamaha2121]

it will run now but when i put the choke in iot will bog down and die

 

[Larry's Shee]

Then you either have a dirty carb/plugged jet, or a massive air leak somewhere

 

[newtoyamaha2121]

that would be a huge air leak but i dont think it is because it will idle perfectly

 

[Monoxide]

My Blaster Boggs out after I pull a wheelie and set it back down. And when it's just sitting, wile not running the gas runs out of the hose on the back of the carb. Does this mean my floats are sticking? Or does it need a carb rebuild?

 

[Quadman1]

Might want to make your own post

 

[Blaaster]

Crap in the needle and seat, float sticking, wrong float level setting or a bad needle.

You could need a re build and clean.