Hi. I'm having some MORE trouble with my blaster. I think that it is a carb problem. I have the 28mm oko carb, whick is basically the PWK carb because it came with a Keihin book. With my mods listed in my signature below, I'm running a 42 pilot jet and a 148 main jet. Whats happening is that the quad is hard to start(unless it's been sitting for over a half hour with the gas off) and when it runs, it bogs out unless I pin it, then it jumps, but if I let off the throttle, it starts to die. If I juice it after I hear it starting to die, it jumps up again, but it only does this for a while until it dies and won't start again. I adjusted the float hight to 19mm (this is what it says to do in the book) and when I do, it slowly leaks out of the overflow on the bottom of the carb.It only does that if I kick it over, or when it's running. I don't notice it dripping as fast if it's just sitting. I tried lowering the float and it stops dripping even when it runs, but it does the same thing when it is running. I took the carb apart and cleaned everything meticulously. The reeds seal up good, and I have good spark also. I need to get this thing running before this saturday, and I am getting really frustrated. Any input would be greatly appreciated. Thanks
