how does my engine case look

[ttracer6x]

thanks for looking

 

[Surfrjag]

is there a problem with it??

 

[ttracer6x]

it has been laying around just wanted to know if you guys see in any problems that i don't see

 

[Awk08]

is this a trick question ????

looks normal, coils on stator are pretty clean, no mud/dirt on them, so musta been sealed good

 

[Surfrjag]

just be sure the crank case area doesnt have any cracks or cracks anywhere for that matter. should be fine i dont see anything in the pics but its kinda hard to tell.

 

[ttracer6x]

i here ya pics were taken on my neighbors i pad not our nice camera

 

[Awk08]

looks like the rest of the base gasket needs cleaned off, use some brake cleaner and a razor blade, layed down flat, do not gouge the aluminum, just the gasket still stuck on there

and use only factory or cometic base gasket, no green vito's/k&s base gaskets, they will leak and fry your sh*t

 

[slickerthanyou]

Get that damn washer outta the crank case!

 

[sicivicdude]

The output shaft seal is busted. Other than that, it looks good.

 

[Awk08]

i automatically assumed it would be recieving all new seals, and crank bearings,
as they all should when torn down this far

 

[ttracer6x]

yea i plan on rebuilding it i picked it for like 25$ about six months or so ago

 

[sicivicdude]

Look over the inside real well. Down there near the washer, there's impact damage. That's not necessarily a problem but definitely looks like it might need a closer inspection. Look on the outside for "smushed" areas. Any broken areas need attention before you run it otherwise you'll have an airleak.