how do i put my blaster carb together as far as how low to go with the slide.

[kevinz]

I have a 2002 blaster an i don't know how to get the carb adjusted an set.to begin with i don't know how far the slide goes down so i can adjust the mixture.i would appreciate some help.thanks kevinz

 

[Wifesblaster]

Hey Kevin. We're going to need a little more info. Is the TORS removed?

 

[Wifesblaster]

The slide height is adjusted with the idle screw.

 

[Blaaster]

I have a 2002 blaster an i don't know how to get the carb adjusted an set.to begin with i don't know how far the slide goes down so i can adjust the mixture.i would appreciate some help.thanks kevinz

Adjust the slide until it sits at the bottom.

Adjust the idle screw until it raises about 1/16".

Adjust the air screw 1 1/2 turns out from lightly seated.

Now start the motor and warm it up to operating temperature, now set the idle mixture.

Idle adjusting.

Set float level.

Start with air screw 1.5 turns out.

Set idle screw so that it has some sort of idle. With TORS it is the big screw under seat on top of unit. With no TORS is is the brass screw midway down carb body.

Warm up motor and then set idle screw for a faster idle, 2000rpm+

Adjust air screw either way to get the fastest idle.

Adjust air screw a little at a time leaving 10 secs or until the motor to responds.

Re adjust idle screw for desired idle .

 

[kevinz]

Thanks alot blaaster.that will help alot but i can't get my idle screw to turn i may have to get an ease out an replace it.but that helped me alot.thank you.