hole on left side of motor

[bigdaddycaddymane]

i have two motors one of them is just like in the haynes manual, the other is just like it too with the exception of a threaded hole on the left side close to where the sprocket shaft comes out. on my normal motor there is a place where it looks like it could go but no hole, the one with the hole goes into the transmission area and has treads on the inside of it. i bought it already took apart and would like to know if any one knows what it was used for i will probably just put a bolt in it and forget about it.

 

[89custom]

take a picture of it, and this is sorta the wrong section.

 

[blasterfreek30]

moved it for ya

 

[bigdaddycaddymane]

[/IMG]

 

[bigdaddycaddymane]

[/IMG]

 

[bigdaddycaddymane]

[/IMG]

 

[bigdaddycaddymane]

the first one is of the hole in question hope its nothing important already put it together. the second one is a close up. the third is the engine that originally came in my blaster it does not have the hole with threads in it although it does have a spot to put it. the second engine i bought was in almost in pieces, bad crank, chipped up case around the stator. the original engine i had to work with was bad crank, hole in the bottom of crank case you could touch the crank shaft through hole and hole in between the crank and balancer, and tore up transmission. trying to get this one halfway deacent. does any body know if yamabond 5 will work for sealling the cases because i used it and i dont want to split the cases again if i have to. i can but i dont want to. more work.

 

[Unstock240]

I never have seen anything used on that spot. Most likely something a dt200 model would have used.

 

[liljatownboy]

i think it is the oil eyeglass check.

 

[bigdaddycaddymane]

i thought that was on the clutch cover on the right side of the engine. this hole is on the left side of the engine.

 

[liljatownboy]

it was just a guess i wasnt sure

 

[liljatownboy]

does a blaster even have an oil eyeglass

 

[Unstock240]

does a blaster even have an oil eyeglass

Yea on the right side case right by the footpeg area. About that hole, just looked at mine and has a freeze plug in it. Nothing in the manual about anything there probably a watercooled attachment.

 

[liljatownboy]

ok he answered it so its not the eyeglass

 

[bigdaddycaddymane]

thanx yall i will just screw in a bolt and plug it up.

 

[Bastardblaster]

Fill it with some jb welb, I love that stuff

 

[Luni]

I dont know if Id fill it with JB weld, Id prolly put some yamabond on the screw and thread it in and tighten it down.

 

[brandoz28]

good lord another thread from the crypt!!!!!!!!!!! this thing is a year and a half old....

and mine just had a bolt in that hole

 

[Whitty21]

haha, that is an oldie