Hi, im scott

[scottemus]

Hey there everyone. My names Scott, and i'm from Toronto,On. I recently bought a 1991 Blaster for 700$, and been enjoying it ever since.

uptill a couple days ago everything was running beautifully till it died on me on the way back to the barn. looks like ill be doing a engine pull to figure it all out.
I can get it to start up, but runs horribly.

anyways just saying hi!

Scott

 

[scotj77]

No I'm Scot! lol
Welcome Dude!!!!!!!

could be a lot of things that cause it to run badly. broken reed petal. malfunctioning tors unit. no oil mix. bad plug or wire. ton's of things could be wrong with such little detail

 

[Prime]

Welcome to the forum!

 

[piezzi]

Welcome dude....and nice blaster. What kinda truck you driving?

 

[Awk08]

welcome scott
compression test, check reeds, clean carb, change plug, check for good spark, and fuel flow
lots of things to check before pulling the motor

theres troubleshooting link below my sig pic, check it out

 

[scottemus]

thanks for the welcome..its a ford ranger in the pic.

ive ended up pulling the engine today..piston is toast and the bearing is too...im trying to get the stator rotar off....but i cannot i bought a puller but doesnt seem to wanna come off...

any suggestions?

 

[79 bronco]

Welcome!!!!!!!!!!!!!!!!!

 

[scotj77]

so you have the nut off the flywheel and the big spacer/washer behind it? if that is the case try and impact to break it free. or some more muscle. lol

 

[1995blaster]

i had to use a impact to gett it off with a puller also.

 

[schmidtsandwich]

big hammer!!!! welcome to the forum