handguards on yamaha blaster(Hebo - Integral)

[silverlight]

hey
i was wondering if any of you have been into this handguards
its Hebo - Integral, and they are universal(not sure what names in english, just guessed) what i mean is it that its made to fit most, i have problems making it fit for my blaster, any tips?

its just that their little room to place it and my clutch handle is alittle bended so it didnt get onto right :S

http://img66.imageshack.us/img66/880/imageshackc.jpg
there you will see infront of my blaster(dirty)


If you got a tip on what handguards i could get please tell me, dont wanna waste more money..

 

[MINIGfather]

Would they work if your levers werent bent forward? Atleast in the pic they look bent forward and the ones end is curled. Just curious? I like the guards I would prob straighten the levers and then try them on.

 

[REEDracing94]

i had to get shorter levers for mine to work..or just cut the stock ones

 

[chriscblaster]

I have seen a few blastys with very similar design to that. I think they were accerbis

if you pulled the lever up more they should fit on, but you might prefer the lever being more down

 

[06kid]

yeah just get shorter levers or just cut the old ones and DO NOT try to bend the levers back you will just break them and have to get new ones anyway lol

 

[chriscblaster]

i didnt mean bend i ment loosen and make them more upright lol

 

[NOVIS]

yeah just get shorter levers or just cut the old ones and DO NOT try to bend the levers back you will just break them and have to get new ones anyway lol

i heated mine up with a torch and they bent just fine. they didnt crack or break at all.

 

[stephen12091985]

i like the pro taper handguards

http://www.btosports.com/p/ProHG

 

[silverlight]

i now have the acerbiz ones, anyway, i bended the clutch lever with my arms without heating, but took it back because it didnt get right, clutch didnt go far enough in, and didnt get up the screw to fix that, i was in track