I bought a used wiseco piston bored over 20 today. The only problem is, is that the topend is missing three studs. Can i take these off my old topend and install in my new one or do i have to go to a machine shop and have them put them in? And another question where can i find a new hardware kit for the crankcase?
Got the piston
- Thread starter zippy4
- Start date
you can swap out the studs but you should use new. they'll still work. a trick putting them in and out is with using 2 nuts to tighten together on the stud then if your taking them out use the bottom nut to loosen/unscrew the studs out and when you install on other top end use the top nut to put into place then just unloosen the 2 nuts and take them off.
