frusterated

[xcaseylanex]

i need some advice my blaster motor is leaking mad oil and i just found out one of my screws in the side of the motor right side was jamed in there cause the previece owner lost the one so im sure that sh*ts stripped out. and its leaking out of the spindle so its jus so frusterating ive replaced about everything on this damn bike and i just want a new blaster but i cant afford it. so what should i do. i dont no if these problems can be fixed.
any suggestions/help?

 

[Awk08]

does your blaster still have the oil injection or has it been removed?? the oil block off plate i made for mine was what was leaking, till i made a new gasket and some rtv sealent, i have'nt seen a drip since, and i would think you could retap that stripped bolt and put a new clutch cover gasket with a little rtv, and you should be fixed up

 

[specialized7]

funny you say that, i put my new clutch cover on yesterday, and removed my oil injection. made a block off plate and it was leaking like a b*tch , i had to add some rtv sealant but i havent checked it yet.
i would try to retap the hole and use some sealer and a new gaket

 

[xcaseylanex]

how do you retap the hole and can i buy a bottom end seals and gasket kit. sh*t iv replaced every other damn seal and gasket on this bike this cant be to hard lol

 

[randy2112]

You dont need a block off plate! you just remove the gear on the inside of the clutch cover. It stays sealed just like from the factory and the pump doesn't spin anymore.