so i just picked up 2, 74' dt360 running motors with 3 extra new pistons 1 extra cylinder and all electronics for less then a bill! so i was wondering if anyone has ever done this swap into a blaster. seems like it will be a good power increase over the blaster motor. just would like to see if anyone has some more info on these motors. thanks in advance!
dt 360 motor
- Thread starter c4wheeler
- Start date
I was looking up the spec's on the bike, 32 hp.
I had a 74 DT250, power was pretty flat. No real powerband like we are used to.
First and second gear wheelies but not much more.
I raised the ports and tightened up the squish and made a pipe that livened it up.
The DT250 was a torquey tractor, if the 350 is anything like that, it would be
good in an ATV and respond well to tuning.
Steve
I had a 74 DT250, power was pretty flat. No real powerband like we are used to.
First and second gear wheelies but not much more.
I raised the ports and tightened up the squish and made a pipe that livened it up.
The DT250 was a torquey tractor, if the 350 is anything like that, it would be
good in an ATV and respond well to tuning.
Steve
Should make a great torque monster. Just don't try to rev it too high. As in most of these builds the pipe will be the hardest part.
