*I NEED HELP!* When I turn my handle bars to the left on my blaster while idling it dies. Not sure but I think it might cut out while turning left and not idling. Think it might be a short in the ignition wiring. *HELP*
Dies When I turn the bars
- Thread starter I race a Yamaha Blaster
- Start date
I would put my bet on the wiring. But it could be the throttle cable too, check the adjustment at the handle bars.
its your wiring, one of your keyswitch wires are bare and grounding out on the frame when you turn the bars a certain way...id bet on it lol
^ that or something with the throttle cable. if its just at idle and stalls like it doesnt have enough gas then its throttle cable but if you have it rev'ed up and it totaly cuts out right there its wiring.
I don't think the throttle stop would let it die like that if the cable gets kinked or pulled it would rev up not down, but it could be either on my moneys on the wires
i had this problem the throttle cable was broke under the little rubber thing and when i turned it would shut off..
I have that same exact problem right now, the cable tore in 2 right behind the adjustment. I can push my cable down and it will idle up and pull it up and it will idle real low or die.
I had the same problem check the throttle cable, i ended up rerouting mine because the kid who had it before me obviously had no idea what he was doing.
