If your stuck on how to figure out the correct float level for a stock carb. here it is...it took me hours to get it right, but finaly (thanks 305!) i got my blasty to stop pissing...I:II:II:I
1) remove bowl.
2) remove gasket.
3) flip carb upside down.
4) you should be looking on the choke side of the carb, where the little notch is, where you would be able to see the side of the gasket if it was in place.
5) the correct float height should be between 20-21.5mm from the bottom of the notch to the top of the float. (i held a 12" ruler up and eyed it out)
the float tang should be resting on the needle valve, but not compressing it. Bend the tang accordingly to adjust your measurement.
Hope this helps anyone!!
vile
1) remove bowl.
2) remove gasket.
3) flip carb upside down.
4) you should be looking on the choke side of the carb, where the little notch is, where you would be able to see the side of the gasket if it was in place.
5) the correct float height should be between 20-21.5mm from the bottom of the notch to the top of the float. (i held a 12" ruler up and eyed it out)
the float tang should be resting on the needle valve, but not compressing it. Bend the tang accordingly to adjust your measurement.
Hope this helps anyone!!
vile