clutch not disengaging

[01blaster]

i just did a full rebuild on the blaster and when i pull the lever it moves the piece that moves the clutch but it does not disengage the motor. the bike still moves but wont stop when i pull the clutch. could this just be adjustment or is the clutch bad. i figured it is still good if the bike is still moving

 

[01blaster]

bump bump

 

[blasterjarred]

i think u just have to adjust it cus my jumps a lil when i try to start it and some one told me i just have to do some adjusting i gess it would be on the clutch lever

 

[01blaster]

no its not the lever because its moving the parts. i think its internal

 

[Unstock240]

The clutch arm might not be aligned. The point on the end of the arm with the cable unhooked should align with a casting mark on the case. Take your finger with it unhooked push it till it stops it should stop on the alignment mark. If not you need to adjust the push rod screw in the center of the clutch basket. Another thing the manual says to soak all the clutch plates in oil when reassembling.

 

[01blaster]

i got it now. it was the screw in the center of the clutch basket

 

[rrawlings]

did you remembedr the little ball between the two rods?