Clutch linkage on casing stuck

[Will holcomb]

I just trade for this blaster and I was riding the other night and the clutch lever all of a sudden stop engaging like pulling in on handle so I started looking and the linkage on the case was stuck in the engage point and wasn't releasing back to its starting point ...what could be causing this u can tap it back around and pull handle and gets stuck again...thanks again for the info in advance

 

[Awk08]

sounds like that actuator thats getting stuck is worn and allowing the rod to pass by and trap it, instead of getting pushed towards the other side by it.

you may have to take the clutch cover off and pull the pressure plate to relieve any pressure, to get the actuator to pull up n out ?

you'll need to buy a new/used actuator on here or ebay

 

[Will holcomb]

Yeah like u can tap the one on the casing back to it release point and it feels really tight when ur doing this all most like it's dry not lubed ...Will I.need a new set of clutch while in the there

 

[Fast6hand]

I would also inspect the rods for a mushroomed head and ball while your in there.