If you have the engine out just tip the engine. The ball is seperate from the shaft it will just fall. That is if it is not siezed to the rod witch can be common.
are we talkin 'bout the bearing on the output shaft, or one of the others iside the clutch cover, or are we talkin 'bout the little ball that goes in between the 2 clutch lever push rods???
If you think that it is stuck you can pull out the arm that your clutch cable attaches to, and blow compressed air down the hole[seal the blow gun with a rag or somthing]. This has worked for me in the past..
Old post but I have the same problem...no ball bearing at all! Someone has had the motor apart in the past because it has a hot rods crank in it so im guessing they didnt know about it. Anyways is there anything else that will work like a BB or or a ball bearing out of something else so i dont have to order 1? If someone knows a place i could get 1 the help would be much appreciated!
yea, i called my old neighbor from my home state that owns & runs his own motorcycle repair shop...he had 100 on hand at a $1 a piece so hes sending me a few for the price of 1! Anyways for anybody else that comes across this thread needing to know the size its a 3/16 steel ball.