carb. replacment

[billysblaster]

i am ordering a keilen 28mm carb. they will jet to my needs but not sure what to get. I have a k&n filter and a 66.5 piston and bore. what size jets would you recomend. i am running stock setup in there right now.

 

[little3mil]

hey this is fairly new here maybe someone has a 28mm and slighty the same setup...? check it out but start high and work your way down... dont want to lean it out

heres the link
http://www.blasterforum.com/off-topic-7/jetting-numbers-solution-17259/

 

[blasterfreek30]

mabe a 145 main and 40 pilot and work ur way down from there

 

[Awk08]

i've checked into a few places that claim they will jet close for your needs, carbpartswarehouse.com, and a couple that have tons of experience with blasters are snydermotorsports and project blaster, maybe give them a call and see what they say,
dont know what your lookin to spend, but his one comes pre-jetted for your mods, with a cable too, good deal, imo..................
http://cgi.ebay.com/ebaymotors/28MM...136346QQptZMotorsQ5fATVQ5fPartsQ5fAccessories