Carb Bowl

[Quadrider10]

i need a bowl for my carb. the one i have, the screw got stripped, and it also leaks a tiny bit from the outlet on the bottom. if anyone has one, that would be awesome, all i need is the bowl and screw for the outlet.

thanks!

 

[yamaha28]

I can sell ya a whole stock carb

 

[piezzi]

Just use some jb weld or whatever to fill the hole so you can continue using your existing bowl. The drain screw is just a 'nice to have' item. The carb won't care that there's no screw.

 

[Quadrider10]

i know, but since i travel with it IN my car, i like to drain the gas so its less smelly. and i kinda dont want a whole new carb, cause of the fact 1 i dont have that muchg money, and 2, i just rejeted! i dont want to do it again lol

 

[piezzi]

You can burn down the fuel in the bowl before you put it in the car. That's what I do because my bowl drain screw was fug'd up when I got it.

 

[Quadrider10]

Yea that's true.... But the bad thi g about that is that it's runed really Ryan lean for like a minute.

 

[yamaha28]

I don't think it is, why would it be running lean?

 

[Quadrider10]

if u cut the fuel, than more air goes into engine, making it run lean..... im pretty sure....

 

[yamaha28]

I am not thinkin so, I could be wrong but. The blasty will suck the amount of gas needed to run and if you are pre-mixing, it will have the correct amount of oil burning with the gas. The blaster will die when it runs out of gas, it doesn't run out of oil before gas.

The time it starts to die from lack of gas to when it is dead will not be enough to do any damage. It bogs when dying from starvation of gas so it doesn't suck more air then normal.

Hope that makes sense, it kinda does to me.

 

[Quadrider10]

Yupp. Make senese. Thanks!!!