cant get blaster to start. new piston

[pvt. blaster]

just got it bored out to 40 and new piston did it my self . tryed new sparkplug but it still will not start any suggestions

 

[yb200]

do you have spark???

fuel to the carb????

 

[pvt. blaster]

yep check plug and should have gas to carb. when puting in new piston i lightly oiled it and the cyilender could that be a factor

 

[bag0b0nez]

no that wouldnt be the factor go over everything. check ur reeds. make sure clean airfilter. check all connectiongs. disconnect p.o.s. tors system. make sure fresh gas. key on run switch one.

 

[pvt. blaster]

put new gas checked reeds they are good dont have key hot wired it worked befor and have spark should it be hard to start. any suggestions on how to start it after the new piston and bore was done. the pos tors systom does that have have 2 wires that go to the carb yellow and black

 

[motoman9911]

Do you have spark? Take the spark plug out and kick the quad over. Make sure the plug cap is still on the spark plug though.

 

[pvt. blaster]

did that and i do have spark

 

[blasterdemon7]

Nobody is going to say check your compression

 

[yb200]

is the plug wet ?

 

[powerband]

no i was working on it with him and the plug isnt wet and deeefinitly have compresion

 

[motoman9911]

Will it fire with starting fluid?

 

[brandoz28]

did you put the piston in the right way?

 

[pvt. blaster]

yep arrow on piston tords egsaust

 

[brandoz28]

are you getting gas to the cylinder?

 

[pvt. blaster]

i dont know how do you check

 

[brandoz28]

does the plug have fuel on it when you pull it?

 

[blasterdemon7]

Im not trying to be a jerk but did you make sure you turned on the gas at the tank?That is something easy to over look.

 

[yb200]

how long was the bike sitting before you rebuilt it

 

[bag0b0nez]

how long was the bike sitting before you rebuilt it

i like where ur going clean ur carb!

 

[yb200]

i like where ur going clean ur carb!

yea .