can someone help please...

[bumble bee]

i wanna change my engine oil, is it safe to use yamalube four stroke
SAE 10W-50 and what amount do i put in the engine???

 

[4cfed]

you mean transmission oil??? most will recoomend belray gear saver

 

[bumble bee]

yeah transmission oil...i went to the dealer and that's what they gave me...and i live in a small island so it's hard to get my hands on good oil...

 

[quam]

that yamalube is fine man. it's the wet clutch stuff right?
ALWAYS use wet clutch friendly tranny oil.

 

[blasterkid114]

4cfed said it the belray gear saver is the best way to go and for measurement i always guesstimate kinda just down in there but i usually dont put in more than like 3/4 of a quart

 

[Unstock240]

24oz or 3/4 qt is the exact amount needed. 10W50 is on the thick side, the engine wont spin as freely with 10w30, and in winter it will be like sludge. You can use atf as well, not sure what type people use. 4 stroke/2stroke doesnt really matter when its in the gaerbox either.

 

[quam]

i wouldn't use atf on any wetclutch system.
actually 10w50 or 10w40 works great! i use that in my street bike as well.

 

[bumble bee]

alright!!!thanks guys...i see one of you is from guam, was up bro, i'm from saipan!!!it sucks out here cuz we dont carry parts for blaster, i usually order...i bet you guys have a lot of parts there??anyways bruddahs, thanks again!!!

 

[DUALSTROKE]

i wouldn't use atf on any wetclutch system.
actually 10w50 or 10w40 works great! i use that in my street bike as well.

To each his own but it works great and better then bel ray gear saver.IMO
TYPE F ATF only in my machines.

 

[FLOTEK]

belray gearsaver or type F atf works the best ,nearly every top reputable 2 stroke engine builder in the country uses and recommneds type f atf ,it is used on 25,000 dollar+ drag banshees where every detail matters ,type f has friction modifers,thin yet protects and has a high flash point ,free of dangerous detergent additives like motor oils have . its used in old style fords which are similair to our motorcyle disk trannys.type f shows 10% more torque than other oils on dyno results according to a couple top builders on planet sand .com.it is used so often because it works ,not because its cheap.four poke and 2 stroke lower end oil should not be the same ,they have a different engine design to them and they have different duties like cooling a piston and such